Assemble some cool planes based on aircraft found around India. These planes actually fly, so launch them as far as you can!
For pieces on the left (1,2,3) stick 3 over 2 and then both over 1. Then stick 2 and 3 behind 1.
Apply glue to the inside of the body and glue the tail piece to the back and nose piece to the front.
Glue the body together and attach clips to each end to secure them.
Slot the tail in and glue down onto the supports.
Fold the thin part of the wing down and glue.
Stick the wing to the top of the body.
Glue the pieces 1 over the other following the design.
Glue the wings to the base.
Slot the tail into the back and glue down.
Stick the pieces together following the design.
Stick both halve together.
Glue the body to the wings.
FIGHTER JET 2
Glue all the pieces together.
Stick the halves back to back.
Make a small slit in the tail piece and slot into the back. Glue down.
Slip the wings into the slot of the plane and glue to the supports.
Tie 3 rubber bands together and slip one end into the hook of the launcher.
Slot the MDF pieces together.
Hook the bottom of the plane onto the end of the rubber bands.
Pull the plane back at an angle and release!